User Manual

8
II-2. Connect AP to a switch
If PoE switch is used, make sure the Ethernet cable is connected to Ethernet
port from the PoE switch. The AP will be powered by the switch.
Please wait a moment for the AP to start up. The AP is ready when the LED is
Blue.
Do not use the power adapter if you are using a PoE switch.
II-3. Mounting
To mount the device to a ceiling, please follow the instructions below and
refer to diagram A & B.
Wooden Ceiling:
Please refer to the figure below:
1. By using the holes A on the ceiling bracket, identify and mark correct
screw positions of the desired mounting location.
2. Where necessary, drill a hole (of radius smaller than the radius of the
provided screws) on each of the marked screw positions.