User Manual

II-6. WPS Setup

If your wireless device supports WPS (Wi-Fi Protected Setup) then you can use this

method to connect to the BR-6478 AC V2’s Wi-Fi network.

1. Press the WPS/Reset button on the BR-6478 AC V2 for 2 seconds to activate

WPS. The LED will then flash blue to indicate that WPS is active.

2. Within two minutes, press the WPS button on the wireless device/client to

activate its WPS.

3. The devices will establish a connection. Repeat for additional wireless devices.

Please check the instructions for your wireless device for how long

you need to hold down its WPS button to activate WPS.

II-7. Reset to Factory Default Settings

If you experience problems with your BR-6478 AC V2, you can reset the device

back to its factory settings. This resets all settings back to default.

1. Press and hold the WPS/Reset button found on the rear base of the

product for at least 10 seconds.

2. Release the button when the LED is flashing blue.

3. Wait for the BR-6478 AC V2 to restart.