Quick Installation Guide

8
PIN CODE
This is your device’s PIN code for Wi-Fi Protected Setup
(WPS).
5. I forgot my password.
a. Reset the router to its factory default settings and use the default username
admin and default password 1234. Default settings are displayed on the product
label on the back of the device, as shown above.
6. My BR-6428nS V4 has a weak wireless signal in range extender
mode.
a. Weak signals are usually caused by interference from other devices or obstacles
blocking the BR-6428nS V4’s wireless signal:
b. Keep the device away from other radio devices such as microwaves or wireless
telephones.
c. Do not put the device in the corner of a room or under/nearby metal.
d. Ensure there are as few obstacles as possible between the BR-6428nS V4 and
your wireless network device.
In range extender mode, the BR-6428nS V4’S weak wireless signal may be in turn
caused by a weak signal from your existing router. It’s important to choose a good
location for the BR-6428nS V4 in relation to your existing wireless router. The best
location is roughly in the middle between your existing wireless router and the area
you would like to be covered by the BR-6428nS V4. If you are too far away from
your existing router, then it is difficult for the BR-6428nS V4 to receive a wireless
signal.
7. Do the WAN and LAN ports work the same when the device is in
different modes?
No, the WAN and LAN ports have slightly different functions depending on the
operating mode of the device.
a. In Wi-Fi router mode, the WAN port is for a direct connection to your xDSL
modem. The LAN ports are for wired network clients.
b. In access point mode, the WAN port is not functional. Connect your existing
router to the device’s LAN port, and the other LAN ports can connect wired
network clients.
c. In range extender mode, the WAN port is not functional and the LAN ports are
for wired network clients. Do not connect your existing router to the device’s
WAN or LAN ports, as this can cause the device to malfunction.