Quick Installation Guide

7
d. Connect your computer directly to your modem and check if you can access the
internet. If you can’t, please contact your Internet service provider for
assistance.
3. I can’t open the web based configuration interface.
a. Please ensure your computer is set to use a dynamic IP address. Refer to the
user manual for guidance if you are unsure how to do this.
4. How do I reset my device to factory default settings?
a. To reset the device back to its factory default settings, press and hold the
WPS/Reset button for over 10 seconds, until the power LED begins to flash.
Please wait a few minutes for the product to restart. When the device restarts,
all settings will be reset. Default settings are displayed on the product label on
the back of the device, as shown below:
Router Login
Enter this URL in a web browser to run iQ Setup or
configure advanced settings. You must be connected to
the device by Wi-Fi or Ethernet cable.
Username/Password
This is the default username and password to access the
browser based configuration interface when you go to
the “Router Login” URL (above).
Wi-Fi Network
Name
This is the default Wi-Fi network name for the device.
Search for this name (SSID) and connect to it in order to
access the “Router Login” URL (above).
MAC
A MAC address is unique to every device and is used for
identification within a network. Your device’s unique
MAC address is displayed here.