User Manual

36
II-6. WPS Setup
If your wireless device supports WPS (Wi-Fi
Protected Setup) then you can use this method to
connect to the BR-6428nS V4’s Wi-Fi network.
1. Press the WPS button on the BR-6428nS V4 for
2 – 5 seconds to activate WPS. The WLAN LED will flash to indicate that WPS is
active.
2. Within two minutes, press the WPS button on the wireless device/client to
activate its WPS.
3. The devices will establish a connection. Repeat for additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II-7. Reset to Factory Default Settings
If you experience problems with your BR-6428nS V4, you can reset the device
back to its factory settings. This resets all settings back to default.
1. Press and hold the WPS/Reset button found on the back panel for at least
10 seconds, until the power LED begins to flash.
2. Release the button when the power LED is flashing.
3. Wait for the BR-6428nS V4 to restart. The BR-6428nS V4 is ready for setup
when the power LED displays on.