User manual

II-6. WPS Setup

If your wireless device supports WPS (Wi-Fi Protected Setup) then you can use this

method to connect to the BR-6428nS V3/BR-6228nS V3’s Wi-Fi network.

1. Press the WPS button on the BR-6428nS

V3/BR-6228nS V3 for 2 – 5 seconds to activate

WPS. The WLAN LED will flash to indicate that

WPS is active.

2. Within two minutes, press the WPS button on

the wireless device/client to activate its WPS.

3. The devices will establish a connection. Repeat

for additional wireless devices.

Please check the instructions for your wireless device for how long

you need to hold down its WPS button to activate WPS.

II-7. Reset to Factory Default Settings

If you experience problems with your BR-6428nS V3/BR-6228nS V3, you can

reset the device back to its factory settings. This resets all settings back to

default.

1. Press and hold the WPS/Reset button found on the back panel for at least

10 seconds, until the power LED begins to flash.

2. Release the button when the power LED is flashing.

3. Wait for the BR-6428nS V3/BR-6228nS V3 to restart. The BR-6428nS

V3/BR-6228nS V3 is ready for setup when the power LED displays on.