Operation Manual

47
closethewindow.

Note:Ifyouhaveapop‐upblockerinstalled,you
mayhavetodisableit,orsetittoallowthepop‐up
windowtoshowup.
RootAPSSID InputtheSSIDofthewirelessaccesspointwith
whichyouwishtoconnect. 
SiteSurvey Click“SelectSiteSurvey”andapop‐upwindowwill
appear.Allreachablewirelessaccesspointswillbe
showninthewindow.Selectawirelessaccesspoint
fromthelist,andclick“Done”toestablisha 
connection.Clicking“Refresh”willrenewthelist.
WirelessModule Select“Enable”toturnonthe2.4GHzwireless
signalandselect“Disable”toturnitoff.

Click“Apply”tosavethechanges,orclick“Cancel”todiscardthechanges.Afteryouhave
clicked“Apply”,youwillseethefollowingmessage:



Click“Apply”tosavethechangesandrestartthebroadbandrouter.Ittakesabout60
secondsforthebroadbandroutertorestart.Click“Continue”toconfigureothersettings.

3‐4‐2SecuritySettings

Advancedsecuritysettingsareavailableincertainmodestoenhanceconnectionsecurity.



3‐4‐2‐1Disabled

Connectionencryptionisdisabledunderthismode(notrecommended).
