Operation Manual

42
toconnecttothisrouter.

2.4GHz(B+G+N):Allows802.11b,802.11g,and
802.11nwirelessclientstoconnecttothisrouter
(recommended).
ChannelNumber Selectachannelfromthedropdownmenu.Both
accesspointsmustusethesamechannel(1to13).
MACAddress1 InputtheMACaddressofthewirelessaccesspoint
withwhichyouwishtoconnect.
WirelessModule Select“Enable”toturnonthe2.4GHzwireless
signalandselect“Disable”toturnitoff.

Click“Apply”tosavethechanges,orclick“Cancel”todiscardthechanges.Afteryouhave
clicked“Apply”,youwillseethefollowingmessage:



Click“Apply”tosavethechangesandrestartthebroadbandrouter.Ittakesabout60
secondsforthebroadbandroutertorestart.Click“Continue”toconfigureothersettings.

3‐4‐1‐4APBridge—PointtoMulti‐Point

“APBridge—PointtoMulti‐Point”modeconnectsthisroutertoupto4
otherroutersand
allowsthecomputersconnectedtotheLANportsofeveryroutertocommunicatewith
eachother.

Pleasenotethatwhenyouselectthismode,thisbroadbandrouterwillactasawireless
bridgeonly.Itwillnotacceptotherwirelessclients.Ifyouwishtousethis
functionwitha
wirelessaccesspointthatsupportsWDS,pleaseselect“APBridge—WDS”mode.
