Operation Manual

39
selectthechannelofyourpreference(1to13).
AssociatedClients Click“ShowActiveClients”forthelistofall
connectedwirelessclients.Click“Refresh”inthe
newwindowtorenewthelist,andclick“Close”to
closethewindow.

Note:Ifyouhaveapop‐upblockerinstalled,you
mayhavetodisableit,orsetittoallow
thepop‐up
windowtoshowup.
WirelessModule Select“Enable”toturnonthe2.4GHzwireless
signalandselect“Disable”toturnitoff.

Click“Apply”tosavethechanges,orclick“Cancel”todiscardthechanges.Afteryouhave
clicked“Apply”,youwillseethefollowingmessage:



Click“Apply”tosavethechangesandrestartthebroadbandrouter.Ittakesabout60
secondsforthebroadbandroutertorestart.Click“Continue”toconfigureothersettings.

3‐4‐1‐2Station‐Infrastructure

In“Station‐Infrastructure”mo de,therouteractsasawirelesscommunicationclientand
provideswiredcommunication
forotherwireddevices.Thefollowingsettingswillappearin
“Station‐Infrastructure”mode:


