Operation Manual

39
II-6. WPS Setup
If your wireless device supports WPS (Wi-Fi Protected Setup) then you can use this
method to connect to the BR-6208AC V2’s Wi-Fi network.
1. Press the WPS button on the BR-6208AC V2 for 2 – 5
seconds to activate WPS. The WLAN LED will be lighted
on to indicate that WPS is active.
2. Within two minutes, press the WPS button on the
wireless device/client to activate its WPS.
3. The devices will establish a connection. Repeat for
additional wireless devices.
Please check the instructions for your wireless
device for how long you need to hold down its
WPS button to activate WPS.
II-7. Reset to Factory Default Settings
If you experience problems with your BR-6208AC V2, you can reset the device
back to its factory settings. This resets all settings back to default.
1. Press and hold the WPS/Reset button found on the back panel for at least
10 seconds, until the power LED begins to flash.
2. Release the button when the power LED is flashing.
3. Wait for the BR-6208AC V2 to restart. The BR-6208AC V2 is ready for
setup when the power LED, 2.4GHz Wi-Fi and 5GHz Wi-Fi LEDs display on.