Quick Start Guide

1. Minimum Requirements
The following devices are required to configure the ADSL2+ Router:
z A PC with an Ethernet Adapter and a Web-Browser (Internet Explorer 4.0 or
higher)
z RJ-45 Ethernet cable
z RJ-11 Phone Line
2. Product Package
This package contains the following components:
 One ADSL2+ Router (Annex A or B)
 One Dipole Antenna (only for wireless model)
 One Power Adapter
 One RJ-45 Ethernet Cable (100 cm)
 One RJ-11 Telephone Line (180 cm)
 One Quick Installation Guide
 One CD-ROM (Including the Setup Wizard, Multi-languages Quick Installation
Guide and User Manual)
Rear Panel
1) Antenna Connector ( For wireless model only )
The antenna connector of the router is a reverse SMA connector. It allows you to
connect an external antenna with reverse SMA connector to the router easily.
2) Reset
The Reset button can be used to reset the router or restore to factory defaults.
z If problems occur with your router, power it on and press the router’s reset
button with a pencil tip (for less than 5 seconds) and the router will reboot
and , keeping all your current settings.