Installation guide

Step 2. Connect the router to your LAN network
Connect the router to your PC, hub or switch by attached the Ethernet cable
to the LAN port of the router.
Step 3. Connect the Power Adapter to the Router
Connect the power adapter to the power jack on the rear panel of router.
Step 4. Check ADSL light status
Please check on the front panel of the router for the ADSL LED. The light
indicates whether there is broadband going in your telephone line or not. If
the light is solid we can proceed to the setup. However, if the light is blinking,
please call your Internet Service Provider (ISP) first and inform them about
the flashing ADSL light.
Step 5. Firewall settings.
Please turn off all personal firewall before the setup as they might block the
communication of your PC and the router.
Not e： You must use the power adapter shipped along with the
router , do NOT use any other power adapter from other
sources.