Owner's manual

19
WD‐1000TRtransmitterarepoweredon.
*EnsurethedisplaysettingforyourPC(orlaptop) hadbeenswitched
to clone mode, Projector out mode or dual display mode for enable
externaldisplay.(ReferChapter4.1forthedetailoperation.)
Poorpicturequalityor
intermittentvideo
play.
• CheckifyourvideoresolutionwithHDMIinputfromyourPCdevice
is either 1080p, 1080i, 720p, 576p, or 480p. Please refer to the
“Supported Resolution” chapter where the video frame rate from
yourPCdeviceWD‐1000TRcansupportisdefined.
•
Press INFO./CHANNEL on  the top of WD‐1000RX box to manually
changethewirelesschannel.
• Ensurethetransmissiondistanceislessthan30feet(LOS).

Noaudio.
• CheckifyourTV’svolumeisproperlysetandnotin"MUTE".
• Check if your PC’s (or laptops) audio output has been switched to
HDMIout.
• CheckifyourPC’s(orlaptop’s)audiovolumehasbeenturnedup.
• Ensurethebitrateofaudio
fromthesourcedevicecanbesupported
by WD‐1000TR. Please refer to the details in Chapter 6, Audio Bit
RateSupport.

Ifnoaudio/video
whenresumefrom
PC’ssleepmode.
• Pleasetrytore‐plugtheHDMIcableofTXforre‐detecttheexternal
HDMIdevice
• Please try to reboot WD‐1000TR for re‐synchronize the display
setting.
• PleasetrytorebootyourPC(orlaptop)



4.1WindowsOSDisplaysettingofLaptopforenablesexternaldisplay

 OnWindows7OS:
1. Press
key+Pkey
2. ThereisaPopicondisplayedonthescreen,likesbelow:

3. SelectClonemodeorExtendDisplayorProjectoutonlytoenableexternaldisplay.
