Owner's manual
18
4.Troubleshooting
Problem Solution
TheWD‐1000TRfront
panelpowerindicator
(redLED)doesn'tlight
up.
• CheckifthepowerplugsofWD‐1000TX/WD‐1000RXareproperly
insertedintoafunctioningpoweroutlet.
• MakesurebothPOWERLEDofWD‐1000TX/ZWD1222Rarelitinthe
blue.
Thereisnovideo
displayedonyourTV
screen.
• The wireless link might require 80 seconds to connect between
transmitterandreceiver,andshowvideoontheTVscreen.Please
bepatientandwaitforawhile.
• Verify that the proper cables have been selected and installed
between the
WD‐1000TX (transmitter) input and your High‐end PC
output.
• OnyourTVside(connectedtotheWD‐1000RX),selecttheHDMIas
inputsource.
• Verify the POWER LED and INFO./CHANNEL LED indicator of
WD‐1000TR.
PowerLEDFlashinginBlue
OSDdisplayed:Searchingavailablechannels…..
*
Ensure the transmission range between the transmitter and the
receiver is not over 30 feet (LOS‐line of sight) transmission distance.
Movethetransmitterclosertothereceiver.
*PressINFO./CHANNELonthetopofreceiverboxtomanuallychange
thewirelesschannel.PleasereferChapter3/Step3/
Section8/Item3
forthedetailoperation.
POWERLEDinSolidBlue+SlowandFlashingSOURCELED
OSDdisplayed:NotsupportedVideoformat
*Ensureyourvideoresolutionandframerateisrecognized/supported
andwithinthetransmissionrange.
*Connectthesourcedevicetoyour
TVtocheckandmodifythevideo
formatcompatibility.
* Check your video resolution with HDMI input from your device is
1080p, 1080i, 720p, 576p, 480p. Please refer Chapter 5 for the detail
supportedResolution.
POWERLEDinSolidBlue+STATUSLEDFlashQuickly
OSDdisplayed:NoSignal
*Ensurethepropercablesareconnectedbetweenthetransmitterand
yourPC(orNotebook)devices.
* Ensure your PC (or Source device) devices connected to the










