Manual

4. I can’t access the Internet.

a. Ensure that all cables are connected properly. Try a different Ethernet cable.

b. Check if you can access the browser based configuration interface. If not, please

ensure your Wi-Fi device is set to use a dynamic IP address. If you are unsure

how to do this, try using a computer and refer to the user manual for guidance.

c. Connect a computer directly to your modem and check if you can access the

Internet. If you can’t, please contact your Internet service provider for

assistance.

5. I can’t open the browser based configuration interface.

a. Please ensure your Wi-Fi device is set to use a dynamic IP address. If you are

unsure how to do this, try using a computer and refer to the user manual for

guidance.

6. How do I reset my device to factory default settings?

a. To reset the device back to its factory default settings, press and hold the

WPS/Reset button for over 10 seconds, until the LED displays on and red then

release the button. Please wait a few minutes for the product to restart. When

the device restarts, all settings will be reset. Default settings are displayed on

the product label on the bottom of the device, as shown below:

5GHz Wi-Fi (SSID)

This is the default Wi-Fi network name for the

device. Search for this name (SSID) and connect to

it in order to set up your EW-7288APC.

Wi-Fi Password

This is the default password required to connect

to the default SSID (above).

Web Access

This is the EW-7288APC’s default URL. Enter this

URL in a web browser to run iQ Setup (Wi-Fi

Bridge mode) or access the browser based