User's Manual

2-1-2 Paring your devices

To pair the two devices, please follow the procedures as below.

1. Place the wireless access point and the wireless client between 1 to 3

meters from each other.

2. Pair the devices by pressing the WPS button on the front panel of each

device. You can release the button as soon as the WPS LED begins

flashing.

3. Wait for the pairing process to complete by watching the LEDs on the

devices:

 While pairing is in progress, the WPS LED is flashing.

 After successful pairing, the WPS LED stays on for two minutes.

Note: WPS Pairing is in progress during two minutes after pressing

the WPS button.

2-1-3 Placing and connecting your devices

To place and connect the wireless access point, please follow the

procedures as below.

1. Place the wireless access point on an easily accessible surface near the

home gateway, Cable/DSL Modem or DVR/PVT device.

2. Plug one end of the Ethernet cable into the LAN port of the gateway

device and the other end into the Ethernet port of the wireless access

point.

To place and connect the wireless client, please follow the procedures as

below.

1. Place the wireless client on an easily-accessible surface near the set

top box.

2. Plug one end of the Ethernet cable into the LAN port of the set top

box device and the other end into the Ethernet port of the wireless

client.