Instruction Manual

WEP
Select WEP to enable WEP (Wired Equivalent Privacy) encryption:
Here are descriptions of every setup items:
Item Name
Description
Key Length
There are two types of WEP key length: 64-bit
and 128-bit. Using ‘128-bit’ is safer
than ’64-bit’, but will reduce some data
transfer performance.
Key Format
There are two types of key format: ASCII and
Hex. When you select a key format, the
number of characters of key will be displayed.
For example, if you select ’64-bit’ as key
length, and ‘Hex’ as key format, you’ll see the
message at the right of ‘Key Format’ is ‘Hex
(10 characters), which means the length of
WEP key is 10 characters.
Default Tx Key
You can set up to four sets of WEP key, and you
can decide which key is being used by default
here. If you don’t know which one you should
use, select ‘Key 1’.
Encryption Key
Input WEP key characters here, the number of
characters must be the same as the number
displayed at ‘Key Format’ field. You can use
any alphanumerical characters (0-9, a-z, and
A-Z) if you select ‘ASCII’ key format, and if you
select ‘Hex’ as key format, you can use
characters 0-9, a-f, and A-F.
Enable 802.1x
Authentication
Check this box to enable 802.1x authentication
function. You need a Radius authentication