Instruction Manual

2.4 GHz (G): 2.4GHz band, only allows 802.11g
wireless network client to connect this router
(maximum transfer rate 11Mbps).
2.4 GHz (B+G+N): 2.4GHz Band, Allows
802.11b, 802.11g, and 802.11N wireless
clients. It’s recommends to select this band to
maximize compatibility.
Channel Number
Select the channel number you wish to use;
both access points must use the same channel.
MAC address 1
Input the MAC address of another wireless
access point (the one you wish to connect).
Set Security
Click ‘Set Security’ button to set security
functions of this wireless connection to
improve security. Please refer to chapter
3-2-1-7 for detailed instructions.
When you finished with the settings in this page, you can click ‘Apply’ button to save
changes you made in this page, or you can click ‘Cancel’ to discard changes. After you click
‘Apply’ button, you’ll see the following messages:
Please click ‘Apply’ to save changes you made and restart the broadband router, this
requires about 30 seconds and the broadband router will stop responding (this is normal
and is not malfunction). You can reconnect to this broadband router and continue on other
settings later.
You can click ‘Continue’ to continue on other settings without restart the broadband router,
however, the changes you made will not take effect before you restart the broadband
router.