Instruction Manual

up to 16 alphanumerical characters.
Add
Add the mapping to port forwarding table.
Reset
Remove all inputted values.
NOTE: Please note that every public IP address can be mapped to a single Client PC IP
address only.
All existing DMZ entries will be displayed in ‘Current DMZ Table’:
If you want to delete a specific DMZ entry, check the ‘select’ box of the DMZ entry you want
to delete, then click ‘Delete Selected’ button. (You can select more than one DMZ entries). If
you want to delete all DMZ entries listed here, please click ‘Delete All’ button or you can
also click ‘Reset’ button to unselect all DMZ entries.
When you finished with the settings in this page, you can click ‘Apply’ button to save
changes you made in this page, or you can click ‘Cancel’ to discard changes. After you click
‘Apply’ button, you’ll see the following messages:
Please click ‘Apply’ to save changes you made and restart the broadband router, this
requires about 30 seconds and the broadband router will stop responding (this is normal
and is not malfunction). You can reconnect to this broadband router and continue on other
settings later.