User Guide

65
The following table describes the parameters and buttons of this page:
Field
Description
Destination
IP Address
Enter the IP address of the destination device.
IP Subnet
Mask
Enter the subnet mask of the destination device.
Gateway IP
Address
You can enter the IP address of the next hop in the IP route to
the destination device, or bind with a PVC interface.
Metric
The metric cost for the destination.
Announced
in RIP
This parameter determines if the ADSL router will include the
route to this remote node in its RIP broadcasts. If set to Yes,
the route to this remote node will be propagated to other
hosts through RIP broadcasts. If No, this route is kept private
and is not included in RIP broadcasts.
5.5.3. NAT
Click Advanced Setup > NAT, the page shown in the following figure appears.
In this page, you can set up the NAT (Network Address Translation) function
for your ADSL router. This function allows you to share one WAN IP address
for multiple computers on your LAN.