User Guide

You may select Auto setup by ISP list, Dynamic IP Address, Static IP Address,

PPPoE/PPPoA or Bridge Mode.

5.3.1. Auto setup by ISP list

Select Auto setup by ISP list, click NEXT, and the page as shown in the

following figure appears.

The following table describes the parameters in this page:

Field

Description

Country

Select the country you are in.

ISP

Select your Internet Service Provider (ISP).

VPI

Virtual path identifier (VPI) is the virtual path between two

points in an ATM network. Its valid value is between 0 and

255. Enter the correct VPI provided by your ISP.

VCI

Virtual channel identifier (VCI) is the virtual channel between

two points in an ATM network. Its valid value is between 1

and 65535. Enter the correct VCI provided by your ISP.

Connection

Type

Select a connection type from the dropdown list. You may

select PPPoE/ PPPoA/ Dynamic IP/ Static IP/ Routered IP/

Bridge.

5.3.2. Bridge Mode

Select Bridge Mode, click NEXT, and the page shown in the following figure

will appear.