User's Manual

72

IV‐4‐3. NASSettings

IfusingaNASserverforlocalstorage,configurethesettingsonthispage
accordingtoyourNAS.



Status Displaysthestatus(connectedor
disconnected)ofyournetworkcameraand
NASserver.
NASIP&Sharing
Resource
EnterthelocalIPaddressofyourNASandthe
pathofasharedfoldertostoreyournetwork
camera’srecordings.
Notificationfor
spacefull
Enableordisableemailnotificationswhen
yourstoragespaceisfull.
CycleRecording Enableordisablecyclerecording.When
enabled,cyclerecordingwilloverwritethe
earliestrecordingswhenthestoragespace
becomesfull.Whendisabled,recordingwill
stopwhenstorageisfull.
MaxRecordingFile
Time
Setthemaximumrecordingtimeforeachfile.
Thisappliestoscheduledrecordingsonly.For
motionorsounddetectionrecordingfile
times,referto“EventsMotion/Sound
Detection”.
Authentication Select“Account”andentertheusernameand
passwordinthefieldsbelowifyourNAS
serverrequiresauthentication.Select