User's Manual

8
Parameter Description
Refresh – Refresh card list in the “B“ block.
RT-Set – Open the RT-Set wizard.
Mode – There are two modes: Station and Access Point. If
“Station“ is selected, the card works as a wireless card. If “Access
Point“ is selected, the card will works as a wireless AP.
View – Enable “Status Bar“ and the “D“ block in the utility will
display the current status of the utility.
About – To check the version of the utility, select this item.
This is a list for you to configure several cards in your PC from the
utility.
Show Tray Icon – To show the icon in the system tray, select the
item.
Windows Zero Config – To configure the card from Windows XP
Zero Configuration, check the item.
Radio Off – This function is for you to turn off or turn on the radio
of the card. If the radio is turned off, the card will not work.
Disable Adapter – This function is for you to disable or enable the
card.
It is the status bar that displays the current status of the utility. To
close it, please disable the “Status Bar“ in the “View“ item.
There are several tabs in the block for you to setup the function of
the card. Please refer to the description in the following sections.
3.2 Available Network
When you open the Configuration Utility, the system will scan all the channels to find all the access
points/stations within the accessible range of your card and automatically connect to the wireless
network with the highest signal strength. From the “Available Network” tab, all the networks nearby will
be listed. You can change the connection to another network.
A
B
C
D
E