User's Manual

87
Wi-Fi Password
This is the default password required to connect
to the default SSID (above).
IP
The 192.168.9.2 is the default IP of EW-7288APC.
Enter this IP address in a web browser to run iQ
Setup (Wi-Fi Bridge mode). After setup, the
EW-7288APC will have a different IP address.
7. I forgot my password.
a. Reset the router to its factory default settings and use the default username
admin and default password 1234. Default settings are displayed on the product
label on the bottom of the device, as shown in 6.
8. My EW-7288APC has a weak wireless signal.
Weak signals are usually caused by interference from other devices or obstacles
blocking the EW-7288APC’s wireless signal:
a. Keep the device away from other radio devices such as microwaves or cordless
phones.
b. Do not put the device in the corner of a room or under/nearby metal.
c. Ensure there are as few obstacles as possible between the EW-7288APC and
your wireless network device.
In Wi-Fi bridge mode, the EW-7288APC’s weak wireless signal may be in turn
caused by a weak signal from your existing router. It’s important to choose a good
location for the EW-7288APC in relation to your existing wireless router. The best
location is roughly in the middle between your existing wireless router and the area
you would like to be covered by the EW-7288APC. If you are too far away from your
existing router, then it is difficult for the EW-7288APC to receive a wireless signal.
9. What is the function of the LAN port?
The LAN port has a slightly different function depending on the operating mode
of the device:
a. In access point mode, the LAN port is for a direct connection to your existing
router.
b. In Wi-Fi bridge mode, the LAN port is for a direct connection to a wired network
device, in order to provide Wi-Fi connectivity.