User's Manual

4. I can’t access the Internet.

a. Ensure that all cables are connected properly. Try a different Ethernet cable.

b. Check if you can access the browser based configuration interface. If not, please

ensure your Wi-Fi device is set to use a dynamic IP address. If you are unsure

how to do this, try using a computer and refer to the user manual for guidance.

c. Connect a computer directly to your modem and check if you can access the

Internet. If you can’t, please contact your Internet service provider for

assistance.

5. I can’t open the browser based configuration interface.

a. Please ensure your Wi-Fi device is set to use a dynamic IP address. If you are

unsure how to do this, try using a computer and refer to the user manual for

guidance.

6. How do I reset my device to factory default settings?

a. To reset the device back to its factory default settings, press and hold the

WPS/Reset button for over 10 seconds, until the LED displays on and red. Please

wait a few minutes for the product to restart. When the device restarts, all

settings will be reset. Default settings are displayed on the product label on the

bottom of the device, as shown below:

Wi-Fi SSID

This is the default Wi-Fi network name for the

device. Search for this name (SSID) and connect to

it in order to set up your EW-7288APC.