User's Manual

For more advanced configurations, use the browser based

configuration interface (refer to III. Browser Based

Configuration Interface)

II-6. WPS Setup

In access point mode, if your wireless

device/client supports WPS (Wi-Fi Protected

Setup) then you can use this method to

connect to the EW-7288APC’s Wi-Fi

network. In Wi-Fi bridge mode, you can use

WPS to connect your EW-7288APC to your

existing 5GHz Wi-Fi.

1. Press the WPS button on the

EW-7288APC for 2 – 5 seconds to

activate WPS. The LED will flash blue to

indicate that WPS is active.

2. Within two minutes, press the WPS button on the wireless device/client

(access point mode) or wireless router/access point (Wi-Fi bridge mode) to

activate its WPS.

3. The devices will establish a connection. The LED will display on and blue to

indicate a successful connection.

Please check the instructions for your wireless device for how long

you need to hold down its WPS button to activate WPS.

II-7. Reset to Factory Default Settings