User's Manual

10
(3) If WPS connection is successfully established, ‘WPS’ LED will light
for 5 minutes; if ‘WPS’ LED flashes fast, there’s something error, please
wait for 2 minutes until ‘WPS’ LED off, and try from step(1) again.
When connection is created, the 5G or 2.4G signal LED will turn on.
(4) Please move repeater to the place you wish to use (a better place will
be the center of your house) and insert this repeater into power outlet on
the wall, the wireless connection will be established automatically.
You can check “Wireless signal LED” status to understand signal
reception level.
Steady light: Excellent, Flash: Good, Fast flash: poor.
The quick installation setup is completely done, you can refer to ‘2-2
Repeater mode Advanced Settings’ to login in web UI for other advanced
settings.
WPS LED
Wireless si
g
nal LED
NOTE: If the Signal LED is off, it means this place is out of the
wireless signal of your wireless router, please move this repeater
closer to wireless router until repeater device can receive signal from
wireless router and extend its signal.