User's Manual

Introduction
4
y Antenna Connector
This round connection is standard Reverse SMA connector where any antennas
with Reverse SMA connector can connect to the Access Point.
y DC Adapter Port
Insert the power jack of the power adapter into this port.
y LAN Port
The Access Point’s LAN port is where you connect to your LAN’s network
devices.
y Reset
The Reset button allows you to do one of two things.
1) If problems occur with your Access Point, press the reset button with a
pencil tip (for less than 4 seconds) and the Access Point will re-boot itself,
keeping your original configurations.
2) If problems persist or you experience extreme problems or you forgot your
password, press the reset button until the Power LED goes off and the
Access Point will reset itself to the factory default settings (warning: your
original configurations will be replaced with the factory default settings).