User's Manual

Wireless LAN Access Point Configuration
22
This can protect your wireless network.
Associated Clients
Click “Show Active Clients” button, then an “Active Wireless Client Table”
will pop up. You can see the status of all active wireless stations that are
connecting to the access point.
Block Relay
You can enable this option to block direct communication between the
stations which connect to the same access point.
Wireless Site Survey
When you use this access point as a wireless station for wired network
device to have wireless capability, you have to associate it with a working
access point. Click “Select Site Survey” button, then a “Wireless Site
Survey Table” will pop up. It will list all available access points near by.
You can select one access point in the table and it will join wireless LAN
through this access point.
Click Apply button at the bottom of the screen to save the above configurations. You can now configure
other advance sections or start using the Access Point.
Set Security
“Set Security” let you setup the wireless security for the data transmission between
the bridged access points in “AP Bridge-Point to Point mode”, “AP Bridge-Point to
Multi-Point mode” or “AP Bridge-WDS mode”. It provides “WEP 64bits”, “WEP
128bits”, “WPA (TKIP)”, “WPA2 (AES)” encryption methods.