User Manual

Wireless LAN Access Point Configuration
18
the same WLAN network are the same. The default ESSID is “ default”.
You should assign Alias Name in “ AP mode” , “Station-Ad Hoc mode” ,
“ Station-Infrastructure mode” and “ AP Bridge-WDS mode” .
Channel Number Select the appropriate channel from the list provided to correspond with
your network settings. Channels differ from country to country.
Channel 1-11 (North America)
Channel 1-14 (Japan)
Channel 1-13 (E urope)
There are 14 channels available.
You should assign Alias Name in “ AP mode” , “Station-Ad Hoc mode” ,
“ AP Bridge-Point to Point mode” , “ AP Bridge-Point to Multi-Point mode”
and “ AP Bridge-WDS mode”.
MAC Address If you want to bridge more than one wired Ethernet networks together
with wireless LAN, you have to set this access point to “ AP Bridge-Point
to Point mode” , “ AP Bridge-Point to Multi-Point mode” or “ AP Bridge-
WDS mode” . You have to enter the MAC addresses of other access
points that join the bridging work.
Associated Clients Click “Show Active Clients” button, then an “ Active Wireless Client Table”
will pop up. You can see the status of all active wireless stations that are
connecting to the access point.
Wireless Site Survey When you use this access point as a wireless station for wired network
device to have wireless capability, you have to associate it will an
working access point. Click “ Select Site Survey” button, then a “ Wireless
Site Survey Table” will pop up. It will list all available access points near
by. You can select one access point in the table and it will join wireless
LAN through this access point.
Click Apply button at the bottom of the screen to save the above configurations. You can now configure
other advance sections or start using the Access Point.
Active Wireless Client Table