User Manual

55
Enable (Station wireless ISP functions.
Mode Only) (1):
Disable: disable this function.
Enable: enable this function and the router can also
act as an access point and allow the wireless clients
to associate to it for WAN access service.
Note: In this mode, if you are informed by your
wireless ISP that the wireless settings of the
access point is changed, please configure the
router in this page for matching the settings.
Enable (Station Mode Only): enable this function
and the router will act as a wireless client and after
connecting to WISP network devices, WAN access
service will be built up through wireless. Users are
allowed to access the WAN service through wired
Ethernet or through another wireless band.
SSID (2): This is the name of wireless network. Input the SSID
name that your wireless ISP provides to you.
Channel Number (3):This is the radio frequency used to transmit and
receive the wireless signal. The wireless devices in
the same network should follow the same setting.
Select the channel designated by your wireless ISP.
Wireless Band (4): Check your Wireless ISP service provider either
2.4GHz or 5GHz wireless band is used for the
network and then select the wireless band here.
Site Survey (5): Click „Select Site Survey‟ button, then a “Wireless
Site Survey Table” will pop up. It will list all
available access points nearby. Select the access
point designated by your wireless ISP in the table
and the router will join wireless network through
this access point.