User's Manual

Since most of wireless devices will negotiate with

each other and pick a proper data transfer rate

automatically, it’s not necessary to change this

value unless you know what will happen after

modification.

N Data Rate (6): Same as above, but only for 802.11n clients.

Channel Width (7): Set channel width of wireless radio. Do not modify

default value if you don’t know what it is, default

setting is ‘Auto 20/40 MHz’.

Preamble Type (8): Set the type of preamble, do not modify default

value if you don’t know what it is, default setting is

‘Short Preamble’.

Broadcast ESSID (9): Decide if the wireless router will broadcast its own

ESSID or not. You can hide the ESSID of your

wireless router (set the option to ‘Disable’), so only

people those who know the ESSID of your wireless

router can get connected.

CTS Protect (10): Enabling this setting will reduce the chance of radio

signal collisions between 802.11b and 802.11g/n

wireless access points. It’s recommended to set this

option to ‘Auto’ or ‘Always’. However, if you set to

‘None’, your wireless router should be able to work

fine, too.

WMM (11): The short of Wi-Fi MultiMedia, it will enhance the

data transfer performance of multimedia contents

when they’re being transferred over wireless

network. If you don’t know what it is / not sure if

you need it, it’s safe to set this option to ‘Enable’,

however, default value is ‘Disable’.

After you finish these wireless settings, please click ‘Apply’ button ,

button, and the following message will be displayed on your web