User's Manual

106
Enable IP Check this box to enable IP address based
Filtering (11): filtering, and please select „Deny‟ or „Allow‟
to decide the behavior of IP filtering table. If you
select deny, all IP addresses listed in filtering table
will be denied from connecting to the network; if
you select allow, only IP addresses listed in filtering
table will be able to connect to the network, and
rejecting all other network devices.
IP Filtering All existing IP addresses in filtering table will be
Table (12): listed here.
Add PC (13): Click this button to add a new IP address to IP
filtering table, up to 20 IP addresses can be added.
Please refer to section 3-3-1-1 „Add PC‟ below.
Delete (14): If you want to delete a specific IP address entry,
check the „select‟ box of the IP address you want to
delete, then click „Delete Selected‟ button. (You can
select more than one IP addresses).
Delete All (15): If you want to delete all IP addresses listed here,
please click „Delete All‟ button.
After you finish with all settings, please click „Apply‟ (16) button and the
following message will be displayed on your web browser:
Please click „Continue‟ to back to previous setup menu; to continue on
other setup procedures, or click „Apply‟ to reboot the router so the
settings will take effect (Please wait for about 30 seconds while router is