User Manual

5
Weekly:
• Check and clean solution lter
• Check for obstructions in vacuum pathways
• Quarterly:
• Check pump, plumbing and ttings for leaks
• Check power cords and hoses for tears
CORD STORAGE:
While not in use, storage can be accomplished by wind-
ing cord around handle assy. Cord should be
completely unwound during operation.
CORD SAFETY
• Do not leave appliance when plugged in. Unplug
from outlet when not in use and before servicing
• Do not use with damaged cord or plug. If appliance is
not working as it should, has been dropped, damaged,
le outdoors, or dropped into water, return to service
center for inspection and repair.
• Do not pull or carry by cord, use cord as handle, close
a door on cord, or pull cord around sharp edges or
corners. Do not run this 2000CX-HR/2000FX-HR
over cord. Keep cord away from heated surfaces.
• Do not unplug by pulling cord. To unplug, grasp the
plug, not the cord.
• Do not handle plug or appliance with wet hands.
• is equipment should be stored indoors and not
exposed to rain.
MAINTENANCE:
is 2000CX-HR/2000FX-HR has been engineered and
built to require minimum maintenance. But like any
machine, it does require basic care to keep it in optimum
working condition. Careful attention to these mainte-
nance instructions will give you maximum operating
performance and life expectancy of the machine.
CAUTION: Disconnect the power cord from the outlet
before doing any clean up or maintenance on the ma-
chine
1. Keep the machine clean. Do not allow dust to accu-
mulate on external surfaces or near any moving parts.
2. Aer every job, wipe down the surface of the machine
with a clean damp cloth.
3. Inspect cord for damage. Do not use machine with a
damaged cord.
PERIODIC MAINTENANCE
• Use only chemicals safe for extractors
• Adhere to the appropriate mix ratios for all chemicals
• For optimal performance, it is suggested that the
operator ush the system aer every job or at the end
of the day.
• Pump seals and valves may need to be replaced at the
1000 hour mark if a loss in pressure is noted
Daily:
1. Always keep the machine clean inside and out.
2. Pour 2 gallons of clean hot water in the solution
tank. Turn the pump on and ush the entire system
through the wand nozzles for about a minute to pre-
vent alkaline build-up.
3. Remove dirt and lint build-up inside the lter screen
in the recovery tank. Lint should be cleaned o so
that air ow is not impeded.
4. Check the solution tank strainer in the solution tank.
If lint has accumulated in the screen, remove and
rinse it in clear running water.