Instructions / Assembly

Aer locang and marking the studs,
posion the cleat at the desired height
(nong that the top of shelf will sit
1/2” above the top of cleat) and, using
a level, make marks in the holes and
underneath the cleat.
2
Locate the wall studs* and mark them
near the height that you want the
shelf. It’s crical that at least one
screw is in a stud. Use the provided
wall anchors where studs aren’t
available.**
* Wall studs can be located with an electric stud finder or, depending on the construcon, by lightly tapping the wall with a hammer unl a solid area is found. Studs are
typically 16” apart on center, as are the holes in the cleats.
** Pung screws in at least two studs will greatly increase shelf strength.
1
Slide the groove in the back of the
shelf over the cleat and push down into
the shelf slides securely in place. Use
your hands or a rubber mallet to tap it
down unl it’s ght against the wall.
4
Once the shelf locaon is marked,
screw the including wood screws
ghtly into the studs unl the back of
the cleat is flush against the wall.
Pre-drill the holes and/or use a drill for
the screws if possible.
3
FLOATING SHELF INSTALLATION INSTRUCTIONS
www.CreatedHardwood.com