System information

EAP3000 Users Manual

Version: 1.2

Issue Date: June 12, 2010

Events that can be logged: select from Emergency, Alert, Critical, Error, Warning,

Notification, Information, Debugging.

For each of these events, you may select how to receive notification: Display in event Log,

Notify via SNMP TRAP, Send to Syslog, Display on telnet / SSH monitor.

Click Apply to save your changes.

Click Reset to revert to the previous settings.

Management -> Logs -> Syslog & Email Configuration

The device can be configured to log and e-mail the selected events in the Logs page a specified e-

mail address or a SysLog server.

Log Options

Log Identifier: Every logged message will contain a prefix for easier identification of the source of

the message. The log identifier will be prefixed to both, e-mail and Syslog messages.

Enable E-mail Logs

This section is used to configure e-mail settings for sending logs.

E-Mail Logs is disabled by default. Select the Yes radio box to enable e-mail logs.

E-mail Server address: Enter the IP address or Internet Name of an SMTP server. The device will

connect to this server to send the e-mail logs.

Return E-mail Address: Type the e-mail address where the replies from the SMTP server are to

be sent; for example, failure messages.

Send To E-mail Address: Type the e-mail address where the logs and alerts are to be sent.

Respond to Identd from SMTP Server: Check this radio box to configure the device to respond

to an IDENT request from the SMTP server.

Authentication with SMTP server: If the SMTP server requires authentication before accepting

connections, select either Login Plain or CRAM-MD5 and enter the User Name and Password to be

used for authentication. To disable authentication, select the No Authentication radio box.

Send E-mail logs by Schedule

To receive e-mail logs according to a schedule, select the appropriate schedule. To enable

scheduling, configure the e-mail settings in the Enable E-Mail Logs section. To disable sending

logs, select Never.