System information

EAP3000 Users Manual

Version: 1.2

Issue Date: June 12, 2010

3.4 Wireless -> Access Point -> AP Configuration -> Access Control

This page allows you to define specific MAC addresses to permit or deny connections to the

selected AP. The default is “open” access, which does no filtering on specific MAC addresses.

Default ACL Policy

AP Name: This is the name of the AP that is being configured.

ACL Policy Status: Select between Allow, Deny, or Open. Allow would only permit MAC addresses

in the List below to connect to the AP. Deny would prevent any clients with a MAC address in the

List below to connect to the AP. Open allows any clients to connect and does not filter using the

list of MAC addresses below.

Click Apply to save your changes.

Click Reset to revert to the previous settings.

List of MAC Addresses

This list shows all the MAC addresses of computers and devices which is authorized/unauthorized

(based on the default ACL Policy) to connect to this access point.