User manual

4300T User Manual Edgewater Networks, Inc.
Version 1.7 9
Chapter 2: Getting Started
Physical Installation
The 4300T is designed for desktop, rack or wall-mount installation. Please observe
the following guidelines when installing the system:
 Never assume that the AC cord is disconnected from a power source. Always
check first.
 Always connect the AC power cord to a properly grounded AC outlet to avoid
damage to the system or injury.
 Ensure that the physical location of the installation has adequate air
circulation and meets the minimum operating conditions as provided in the
environmental specifications for the system. These can be found on our
website at www.edgewaternetworks.com.
WARNING: Secure the power supply using a fastener or nearby
shelf so that it does not hang from the power connector.
Desktop Installation
A. Remove the 4300T and accessories from the shipping container.
B. Place the 4300T on a flat, dry surface such as a desktop, shelf or tray.
C. Connect the power and network cables to the appropriate ports on the back of
the system.
Wall-Mount Installation
The 4300T can be wall-mounted using the two mounting brackets on the bottom of
the appliance. We recommend using two round or pan head screws.
A. Install two screws 4 14/16
”
horizontally apart on a wall or other vertical
surface. The screws should protrude from the wall so that you can fit the
appliance between the head of the screw and the wall.
B. If you install the screws in drywall use hollow wall anchors to ensure that the
unit does not pull from the wall due to prolonged strain from the cable and
power connectors.
C. Remove the 4300T and accessories from the shipping container.
D. Hang the 4300T on the wall.
E. Connect the power and network cables to the appropriate ports on the back of
the system.
CAUTION: To reduce the risk of fire, use only 26 AWG or larger wire (e.g.
24, 22, 20, etc.) to connect the T1 port on your unit to an RJ-45 jack.