User manual

4300T User Manual Edgewater Networks, Inc.
Version 1.7 30
D. Scroll down and enter the following parameters:
IP address = LAN IP address of phone e.g. 192.168.1.20
Subnet Mask = Subnet Mask of LAN e.g. 255.255.255.0
TFTP Server = EdgeMarc LAN port IP address= e.g. 192.168.1.1
PLEASE note: The 4300T does TFTP pass-through to the TFTP server address
configured in step E of the “Configuring The VoIP ALG” section of this guide.
Default Router = Default router for data on this subnet. This is usually the LAN IP
address of the 4300T.
DHCP Enabled = No
E. Save the settings.
Note: To reboot your Cisco telephone, press and release the following three buttons
simultaneously: "*" + "6" + Settings . Depending on the firmware version in the
telephone you may need to “Unlock” the configuration to change a parameter. To
unlock the phone, enter * * # on the telephone or by scrolling down the menu
options on the phone to the “Unlock Configuration” option.To change a parameter,
enter * * # on the telephone.
F. Under settings, select MGCP configurations.
G. Set the Media Gateway Controller address = the LAN IP address of the
4300T (e.g. 192.168.1.1).
PLEASE note: The 4300T forwards signaling messages sent to this address by the
phone to the MGCP Server IP Address configured in step D of the “Configuring The
VoIP ALG” section of this guide.
H. Save and Reboot the telephone.
The phone should now register with the 4300T. To complete the installation a one-
time activation code may be required by the network based softswitch or IP PBX.
Please consult your service provider or IT administrator for additional information.