User manual

4300T User Manual Edgewater Networks, Inc.
Version 1.7 27
B. If using VLANs assign the ALG
to a specific VLAN id using the
drop down menu.
C. If you are using MGCP enter the
MGCP Server IP Address,
MGCP Media Gateway Port
and MGCP Notified Entity
Port.
D. If you are using SIP enter the
SIP Server IP Address and
SIP server port. The SIP
server port is the port used by
the SIP registrar. The default
value is port 5060.
E. If you are using H.323 enter the
H.323 Gatekeeper IP
Address.
F. If you are using SCCP enter the
SCCP Call Manager IP
address.
G. Enter the TFTP Server
Address. This address is used
to identify the TFTP server that
contains the images used by IP
phones at boot up. The 4300T
performs a TFTP server relay
function.
PLEASE note: It is not necessary to program in an FTP server address if your IP
phones use the FTP protocol instead of TFTP to retrieve their images. A relay
function is not needed for FTP as the 4300T will forward FTP traffic to the destination
server as programmed in your IP phone.
H. Automatic MGCP Re-registration is used to re-register MGCP endpoints
every time the network or system restarts. Enable this feature to
automatically synchronize the softswitch and phones immediately after a
restart. The default is Enabled.
I. The MGCP Re-registration Rate is used to set the number of MGCP RSIP
messages to send per second to the Media Gateway Controller when re-
registration is needed. If the MGCP Re-registration Rate needs to be changed,
enter a value between 1 and 5. Generally, this value does not need to be
modified. The default value is 5 msg/second.
J. The system re-registers clients when it starts up. If any of these re-
registration requests fail, the system will wait for the configured number of
seconds and then retry the re-registration for the clients that failed. The
system will make at most 10 re-registration requests for failed attempts. If
the MGCP Re-registration Retry Delay needs to be changed, enter a value
between 30 and 60 seconds. Generally, this value does not need to be
modified. The default value is 30 seconds.
K. The H.323 TerminalType is used to specify the type of terminal that the
Voice Applicance should use. It can be either endpoint or gateway. The
Maximum Bandwidth specifies the bandwidth to allow for H.323 calls. The
bandwidth is specified in kbps and if it is set to 0, bandwidth management is