User manual
4200 User Manual Edgewater Networks, Inc.
Version 2.2 7
Serial Console Port
This port is used to establish a local console session with the 4200 using a VT100
terminal or emulation program. The baud rate is 9600. It is used for debug or local
diagnostic purposes only. Primary configuration of the 4200 is performed from a
web browser as covered in “Chapter 3: Configuring the 4200”.
Chapter 2: Getting Started
Physical Installation
The 4200 is designed for either desktop or wall mount installation. Please observe
the following guidelines when installing the system:
Never assume that the AC cord is disconnected from a power source. Always
check first.
Never place objects greater than 5 lbs on top of the 4200 as damage to the
chassis may result.
Always connect the AC power cord to a properly grounded AC outlet to avoid
damage to the system or injury.
Ensure that the physical location of the installation has adequate air
circulation and meets the minimum operating conditions as provided in the
environmental specifications for the system. These can be found on our
website at www.edgewaternetworks.com.
Desktop Installation
A. Remove the 4200 and accessories from the shipping container.
B. Place the 4200 on a flat, dry surface such as a desktop, shelf or tray.
C. Connect the power and network cables to the appropriate ports on the back of
the system.
Wall-Mount Installation
The 4200 can be wall-mounted using the two mounting brackets on the bottom of
the appliance. We recommend using two round or pan head screws.
A. Install two screws 5 14/16
”
horizontally apart on a wall or other vertical
surface. The screws should protrude from the wall so that you can fit the
appliance between the head of the screw and the wall.
B. If you install the screws in drywall use hollow wall anchors to ensure that the
unit does not pull from the wall due to prolonged strain from the cable and
power connectors.
C. Remove the 4200 and accessories from the shipping container.
D. Hang the 4200 on the wall.
E. Connect the power and network cables to the appropriate ports on the back of
the system.
WARNING: Secure the power supply using a fastener or nearby
shelf so that it does not hang from the power connector.