User manual

4200 User Manual Edgewater Networks, Inc.
Version 2.2 6
Back Panel
The back panel of the 4200 contains the following:
 Power connector
 LAN Ethernet ports
 WAN Ethernet port
 Erase switch
 Serial console port
Power Connector
The 4200 comes with an AC power cord and 5vdc, 3.0 Amp power adapter for
connecting to this port.
LAN Ethernet port
The 4200 series LAN interface is a 4-port switch that uses a single IP address. The
LAN Ethernet ports are 10/100 auto sensing ports that should be connected to IP
phones, IADs or PCs installed on the local area network (also known as the private
network).
WAN Ethernet port
The WAN Ethernet port is a 10/100 auto sensing port that should be connected to
the wide area network (also known as the public network) through a WAN
termination device such as an xDSL modem or router
Erase Switch
To erase any custom configuration and restore the 4200 to its factory default state
depress the erase button once, wait for the LEDs to illuminate and press again before
2 seconds expires.
WARNING: Using the Erase switch as outlined above means any
configuration made to the 4200 will be lost. Additionally the VoIP ALG
registration code must be re-entered in the 4200 as covered in Chapter
4: System Diagnostics, viewing the ALG registration code. Erasing the
configuration means that IP phones installed behind the 4200 will not
work and Internet connectivity or network access for PCs will be down
until the system is reconfigured.