User manual

4200 User Manual Edgewater Networks, Inc.
Version 2.2 23
Default Router = Default router for data on this subnet. This is usually the LAN ip
address of the 4200.
DHCP Enabled = No
E. Save the settings.
Note: To reboot your Cisco telephone, press and release the following three buttons
simultaneously: "*" + "6" + Settings . Depending on the firmware version in the
telephone you may need to “Unlock” the configuration to change a parameter. To
unlock the phone, enter * * # on the telephone or by scrolling down the menu
options on the phone to the “Unlock Configuration” option.To change a parameter,
enter * * # on the telephone.
F. Under settings, select MGCP configurations.
G. Set the Media Gateway Controller address = the LAN IP address of the
4200 (egg. 192.168.1.1).
PLEASE note: The 4200 forwards signaling messages sent to this address by the
phone to the MGCP Server IP Address configured in step B of the “Configuring The
VoIP ALG” section of this guide.
H. Save and Reboot the telephone.
The phone should now register with the 4200. To complete the installation a one-
time activation code may be required by the network based softswitch or IP PBX.
Please consult your service provider or IT administrator for additional information.