Users Manual
5、Click the "Upload Code" button, the software will automatically
compile and upload the program, wait for the interface to prompt "
upload successful" and then exit, Cubic can run the program without
connecting to the computer, as shown in 3.6-5
Switch from Arduino mode to Scratch mode and use Cubic again.
As the factory firmware in Cubic controller is replaced by the user's
own program, Scratch mode will not be able to communicate with the
Cubic controller. At this time, when running the program, the software
will prompt "Error, with hardware Communication timed out! ", As
shown in 3.7-1.
八、restore factory firmware
3.6-5 Uploaded successfully
3.7-1 Communication timeout