Manual

Installation sheet

Installation is extremely important for your Washer Dryer to function correctly. :_: :or: t e

STEP 1

PREPARE WASHER DRYER

1, Carefully remove packaging materials from the outside of the Washer Dryer.

2, The Drain hose pipe and the power cord are tied up, Please unstrap.

3, Unscrew and remove four shipping screws, Remove four spacers, !:_:Je _ ?:_e p_e

4, Loosen two front adjustable Washer Dryer legs and lock nuts, Install Vinyl feet below all

four legs,

STEP 2

INSTALL WASHER DRYER

1, Place the drain hose in the drain facility, Prevent hose from collapsing or becoming damaged,

2, Be sure an air tight connection is not made between the drain hose and stand pipe,

3, For best performance the drain hose should not be restricted in any way,

4, The drain stand pipe should be not be higher than 2,6 ft and not lower than 1,64 ft,

5, Caution must be exercised to avoid collapsing or damaging the drain hose,

6, Strap drain hose to the stand pipe,

7, Thread inlet water hose to cold faucet connection, Tighten by hand until snug, Turn 2/3rd by plyer,

8, Do not OVERTIGHTEN, Repeat step for the machine connections at the back of the unit,

9, Turn cold water supply, Check all connections at the water valve and faucet for leaks,

10, Plug power cord into a grounded 220V, 60Hz approved electrical service protected by a

10 amp fuse or a comparable circuit breaker. The Washer Dryer is grounded through the

third and prong _::V:: t_ _:ie _

11, Slide Washer Dryer into position, Make sure the drain hose remains routed straight

through the clip without collapsing or

12, Level Washer Dryer by turning the leveling legs in or out as necessary,

13, Tighten leg lock nuts,

14, The Washer Dryer must be level on four sides, To properly level use a carpenters level, It is

always a good idea to check for level again after the first few washes and re-level if necessary,

Page 5