Manual

Installation sheet

P_ope nsta at[on is ext_<_mey mpo_'tant fo_ yo wash<_ d_ye_ to f_.ncto_ co_'ecty Whe}

y} f_st {)ceve y}u_ washer d_ye_ emove the box a_sd packrsg mate_ a _'}K_ the }t arsd

_sspe(t t ca/efu y yo p;d damag% Kmeda ey co_s ac de very compa_ W a_sd

compar W f om whch :he us was pulchased

STEP 1

PREPARE WASHER DRYER

/ Caoft y X_K_W',' he boxap;d pa<:kagng macasfloK _ he, ouMdc of hcwash_ tffym

2, Tb:_d_a_hos_:_a_d thump(we co_d a_',_see._ed op;th_ back ofth_ unt P_as_ unssapthem

3, U_scewap;d lemow!the fo i shppn<; buts flow the back ofth_!washedTe, R_!mow!th_!fo _

spaces that the b:}ts wee attac}_@ to as w',_ , Stow these p; a safi_ pacx_ p; cas_ you }e_:_d to

move the washer drwr p;th_:_f : m

4 ioo!,en :he :wo font adjustabe egs and ock n@:s ]sb:_ :he ncuded vny feet _mde a f>_l egs

STEP 2

INSTALL WASHER DRYER

1. Place the drain hose in the drain. Do not a[[ow the hose to k kor getdar'aged. Prevet use

flop co aps_g o_ b(cor'n¢; daY_Ned,

2, Do }or nsta t:}edr_,n hose nt:ot:}_ (:ffa } nana_tg%co_}}ect:on (ns_r_ t:}cre ssormarflow

>usa b e

3. For best performance the drain hose should not be restricted in any way.

4. The drain stand pipe should be not be higher than 2.6 ft and not lower than 1.64 ft.

5. Caution must be exercised to avoid collapsing or damaging the drain hose.

8 S rap h_dK_n hose o sand ppe

7 Thead the F_:_t water hose to you_' cod wab:- fauo_t cop;n_c::op; Tghbp; by hap;d up;t sm_g

Turn an addtona /3M :t_n by pyers

8. Do notOVE_TTG_TE_. Hakesu_e ::/ewate_ /eco_/ecto/ _11(1)he back of he ,_/t: ssecue

9 Tun on hecod watesuppy Checks connec onsfo asks

10. Hug he power cord intoa grounded 0/, 60Hzapproved electricalservice protected

by a 10 amp fuse or a comparable circuit breaker. The washe d_yer is grounded through

the third and fourth prong G 8<W ( refer to page 7. ).

11. Slide washe_ @ye into position. Make sure the drain hose remains routed straight

through the dip without collapsing or kinking.

12. Level wash@ d_ye_ by turning the leveling legs in or out as necessary.

13. Tighten leg lock nuts.

14. The washer d_ye_ must be level on four sides. To properly level use a carpenters level. It is

always a good idea to check for level again after the first few washes and re-level if necessary.

Page 5

ill