TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS…………………………………………………1 PREPARING YOUR ICE MAKER FOR USE IMPORTANT SAFETY TIPS.……………………………………………………………….2 GETTING TO KNOW YOUR UNIT… ………………………………………………………..3 OPERATING PROCEDURES & MAINTENANCE UNPACKING YOUR ICE MAKER ..………….…………………………………………...4 CONNECTING YOUR ICE MAKER……………….……….……………………………..4 CLEANING AND MAINTAINING YOUR ICE MAKER….……………………………….4 USING YOUR ICE MAKER……………….……..………………………………………...5 TROUBLESHOOTING...……………………….
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS and INTRODUCTION Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol: ! All safety messages will follow the safety alert symbol and the word “DANGER” or “WARNING”. ! DANGER ! WARNING These words mean: You can be killed or seriously injured if you don’t immediately follow instructions.
PREPARING YOUR ICE MAKER FOR USE IMPORTANT SAFETY TIPS When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock, and/or injury to persons or property. Read all instructions before using any appliance. z Do not operate this or any other appliance with a damaged cord. Connect to properly polarized outlets only. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacle.
GETTING TO KNOW YOUR UNIT 3
OPERATING PROCEDURES & MAINTENANCE UNPACKING YOUR ICE MAKER 1. Remove the exterior and interior packaging. Check that ice basket and ice scoop are included. If any parts are missing, please contact the vendor. 2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it. 3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e., stove, furnace, radiator). Place the ice maker on a level surface.
USING YOUR ICE MAKER 1. Select the size of the ice cube by pressing the “Size” button. If the room temperature is lower than 60°F, it is best to select the small or medium ice size, otherwise the ice cubes might stick together. 2. Open the cover, remove the ice basket and pour water into tank. Keep water level below the “Fill Line”. 3. Press “On” on the control panel to begin the ice making cycle. 4. The ice making cycle lasts 7 to 15 minutes, depending on the size of the ice cubes selected. 5.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Low water level. Stop the ice maker, fill it with water, and then restart it. There is some air in the lines. Open the drain cap on the back of the unit and drain out a small amount of water. Replace the drain cap and attempt to use the unit again. The unit is filled with distilled water- or some other type of water with no impurities.
TECHNICAL SPECIFICATIONS & CIRCUIT DIAGRAM TECHNICAL SPECIFICATIONS Model IP300P Climate Type N Protection Class I Power 110V~120V/60Hz Rated Current 3.
For information on EdgeStar and to view our full line of products, please visit our website: http://www.edgestar.
