Owner`s manual

EdgeStar Portable Dehumidifier 6
Operating the Control Panel continued
The LCD Display will show the room’s relative humidity percentage by
default. Pressing the Increase and Decrease buttons will show the set
humidity for a few seconds, and then revert to the room’s relative
humidity.
Error Codes
In addition to showing the humidity, the display may show the following
error codes:
AS – Humidity sensor error
Power the unit off, and then unplug the unit for 15 minutes. Plug in and
power on. If the issue persists, please contact customer service.
ES – Temperature sensor error
Power the unit off, and then unplug the unit for 15 minutes. Plug in and
power on. If the issue persists, please contact customer service.
EC – Unit malfunction
Please make sure whether the ambient temperature is suitable for the
stated temperature in the manual or not. If not, please operate the unit
under the stated temperature. If the environment temperature is suitable
for the stated temperature, please contact customer service.
P2 – Bucket is full
Empty the water bucket and reinstall it.
The Water Full Light will illuminate when the bucket is ready to be emptied.
The light also turns on when the bucket is not installed or installed
incorrectly. Once the water is drained, and the bucket is properly
installed, the unit will operate normally.
Additional notes about the dehumidifier’s behavior:
 Once the unit reaches the desired set humidity, the power button will
remain lit while the compressor and fan shuts off. You will not be able
to change the fan speed.
 If the power to the unit was interrupted while the compressor was
running, the unit may take a few minutes to start the fan and
compressor.
 If the room’s relative humidity is lower than the set humidity, the unit
will not start the fan and compressor unless you set the unit to run in
Continuous mode.
LCD Display
Water Full Light