Use and Care Guide

Installing the Door Handle

To install the door handle:

1. Open the door and carefully pull the door gasket around the area where the handle is to

be installed.

2. Insert each Phillips head screw through the gasket side of the door until the screw passes

through the door.

3. Align the handle with the screws and tighten the screws with a Phillips head screwdriver

until the handle is flush against the door frame.

Caution: Do not over-tighten the screws as this may cause damage to the handle or to the

stainless steel door.

4. Carefully press the door gasket into its original position.

5. Repeat these steps for the next door.

Installing and Removing the Shelves

To prevent damaging a door gasket, make sure to open each door all the way before pulling

the shelves out of their track.

To Install the Shelves:

1. Open the door completely.

2. Identify the protective stoppers located on the right and left sides of the back of each

wood wine shelf.

3. Lift either the left or right side of the shelf creating a 45° angle. Insert the shelf at the

desired track level and push it back slowly until it stops in place.

4. Gently set the shelf down in place. Make sure the shelf is level.