Use and Care Guide

13
Operation
Installation Check List Before Operation
1. Have all packing materials and tape been removed from the interior and exterior of the
Wine Cooler?
2. Have the installation instructions been followed, including connecting the machine to
electricity? And has proper grounding been installed for the Wine Cooler?
3. Has the machine been leveled?
4. Is the Wine Cooler in a site where the ambient temperature is between 50° F and 95° F
all year round?
5. Is there a clearance of at least 1- 2” at the rear, 1/4” at the top, and 1/4” at the sides for
proper air circulation?
Using the Temperature Control Panel
Use the left button to adjust the left zone’s temperature, and use the right button to
adjust the right zone’s temperature. The temperature displayed can be in Fahrenheit
or Celsius. This wine cooler has a temperature range from 40°F to 65°F for the both
zones.
 This wine cooler has two displays, an Left Zone Display that shows the temperature in the left
section, and a Right Zone Display that shows the temperature in the right section.
 Press the button on the control panel to adjust the temperature in the left zone. The
button will scroll the temperature by one degree increments. Once you see the desired
temperature, stop pressing the button. Note: While pressing the button, it is normal for
the temperature to descend, and then jump to the highest available range. After about
5seconds, the set temperature will revert to the current temperature.
 Press the button on the control panel to adjust the temperature in the right zone. The
button will scroll the temperature by one degree increments. Once you see the desired
temperature, stop pressing the button. Note: While pressing the button, it is normal for
the temperature to descend, and then jump to the highest available range. After about
5seconds, the set temperature will revert to the current temperature.Allow at least 24
hours before storing your wines and to allow the temperature to acclimate.
 Press the button to turn the inner light on or off.
 Press and hold the power button for approximately 3 seconds to turn the unit’s power on
or off. The Run Light will illuminate when the unit is cooling.